|
January 14, 2008
Learn to Chip Carve with BERT HIRT
A few suggestions from Bert
I have had a few inquiries at the meeting, so I thought it would be a good idea to let everybody know as to what we may need:
1: The knives: Over the years I have used all of them, and the one I recommend the most, is the #2 and #6 "Kloetzli" knives. To me, they are the best material, they hold up really well, the handle has four edges that sit well in your hand, and they would not slip when your hand sweats a bit. Also to me, they have the friendliest price. They are available from Thompson's Woodcarving.Their E-mail address is in the Newsletter. (
2: The Sharpening Stones: I really love the ceramic stones(Spyderco). Now, there is a very good two sided pocket-stone (the brown side is the aggressive side, and the white side is the fine side) There are also larger stones from the same manufacturer ( they measure about 2x3 inches) and also in brown and white. They cost a bit more.
The beautiful part of ceramic-stones is the fact that they do NOT hollow out, and when they are plugged up, just make them wet, sprinkle some Comet Cleanser on them, scrub, rinse, and they are as good as new.
I also recommend a small (12") T-Square. I usually have a few, as I am making them myself ( yes, they are accurate), then we need a 6" Ruler in both systems, and I must say: the thinner the Ruler, the easier it is to draw accurately.
We need a good Compass. Try to stay away from the ones that use a pencil ( they can create huge holes in the wood), we also need a Fine Lead Pencil. (.5 mm), and an eraser.
To see more about this seminar please click on this link
|